Jesse Stevens via luv-main wrote:
On 23 Oct 2016 7:02 a.m., "David Turk via luv-main" <luv-main@luv.asn.au <mailto:luv-main@luv.asn.au>> wrote:
Before I reply fully, what general location are you?
State, Suburb like.
Personally I'm out of Melbourne near Ballarat, but the hardware in question is in the CBD in Melbourne.
I'll post here with specifics when I get access to it all again (next few weeks or so).
I should probably also ask in this thread if other open tech is suitable to post here (we have 4 or so 3d printers based on the reprap printer firmware that we're looking to sell cheaply to homes where they'll be used for more than printing Yoda figurines).
Just as a matter of interest is there any standardised way of describing the "print resolution" of 3D printers; I notice there seems to be considerable variation in the 'roughness' of the finished printed artefacts; between top-end and economy 3D printer versions ? regards Rohan McLeod