Hi all,

The TACACS+ server seems to be okay but the switch has an issue.

This ancient HP blade switches are quite unique, and I should have used a Cisco to start with (I just did not one at hand).

Sorry about the noise.

If someone knows these HP blade switches.. I compare it to one in production and cannot see the difference at all.

Regards
Peter

On Mon, Dec 14, 2015 at 4:03 PM, Peter Ross <petrosssit@gmail.com> wrote:
Hi,

I am installing TACACS+ on a CentOS7 server (to replace a Win 2003 based Tacacs)

I could not find a Tacacs+ server in the repositories so I installed this one:


Installation was not a problem, and this test configuration:

key = <key>

user = tester {

          login = PAM
          service = exec {
                      default attribute = permit
                      priv-lvl = 15
          }

}

gives the user tester (local to the server) access on a HP Blade Center switch (a Nortel switch) via

/c/sys/tacacs
prisrv <ip>
on
cmap enabled

if I use the serial console.

A list of commands appears and I get a prompt.

However, if I try ssh, the login seems to work but I do not get a list of commands and no prompt. The terminal is completely quiet after the login (but it stays connected).

I played around a bit but have not been successful.

Do you have an idea what may be missing?

Thanks for answers
Peter