Hi Andrew. Craig beat me to it, and in far better detail than I was typing. It's also going to be simpler to make the changes to UUID or LABEL format without the two additional drives unplugged, as it will give you your full-fat operating system and its tools to make the changes. The one extra step you might need to add to the end of Craig's list would be to force a rebuild of your bootloader configuration (probably Grub) so that the fstab UUID / LABEL changes get propagated into grub's config files. Regards, Morrie. On 16/02/2019 1:15 pm, Andrew Greig via luv-main wrote:
On 16/2/19 1:09 pm, Ben Nisenbaum via luv-main wrote:
Hello Andrew,
Perhaps configure them in /etc/fstab?
ben
Hi Ben,
I am not sure that the /etc/fstab file is even being addressed. Normally when I boot, an early event is the recognition of my SCSI scanner, but the process is not getting that far.
What if I made a "hot" connection (similar to plugging in a USB drive or an SD Card? Would the hardware detection device pick them up and write to the fstab? What if I connected them one at a time?
Thanks for your quick reply.
Andrew
_______________________________________________ luv-main mailing list luv-main@luv.asn.au https://lists.luv.asn.au/cgi-bin/mailman/listinfo/luv-main