Andrew Greig via luv-main wrote:

Hi all,


I have a SCSI scanner Epson GT7000, which I love, but occasionally in the past I may have turned it off, and as a consequence it is not detected at boot

What hardware are you using ?
Adaptec from memory used to show stuff connected on the SCSI bus during boot (Ctrl-A perhaps);
or is " not detected at boot" just inferred ?

regards Rohan McLeod

Hi Rick and Rohan,

I know if I reboot it will come up as surely as the Sun. But I hoped there may have been a command which would run the scsi scan as it does in the boot, similar to restarting the networking.

If I could achieve that I would write it on a sticker and put it on the front of the scanner.

Cheers

Andrew